Welcome to the 56ok.org

If you hear bandwidths of 10 Megabits in, 5 megabits out, and think that that's the service you get in a third world country, this is not for you. This is for people who lust after 10 Megabit connections and can afford one or more consoles. This website shows you how to get creative with online games, and find ones they don't automatically get kicked off of.

To the potential contractor

I need a few different jobs which will be paid over time. I would like these items itemized so I can do parts of jobs with one person and parts with another if necessary. The first is a ring installed in my joystick to prevent clunky corners. I am not handy with most tools so I don't know what I'm doing.

The second should be done by the same person who does the first job. Install two 25 pin adapters. One on each side. one for left handed and one for right handed. The right hand default mode is the same as the left relative to the index finger on either side.
The Third Job is a button remapping device where if I want to remap buttons, I plug one end into the joystick, one end into the PCB, and the middle has RCA wires. There are 2 reasons why I want RCA wires. One is that I had Problems with KY enterprises, and the connectors didn't work right. but the main reason is if I need to replace them, I don't need to necessarily hire a solderer to repair it, but could potentially fix it myself by getting a new RCA male to RCA male cable , which I can pick up cheap at Goodwill, and replace the bad wire. Plus the cats are less likely to chew thick wires like RCA cables. It's easy to plug in, easy to stay in, easy to plug out where desired, and it can be mounted so it's geographically evident what hole is what function. My second joystick maker made it so the connectors are spaghetti wired and hard to follow, like it wasn't meant to be replaced. Never again I will use Quick Connects. 3.5 mm is a little easier to lose hookup if not done right because it'll be on vertical positional insertion, where RCA is inner/outer.

When we get to the Atari 5200, Intellivision, Colecovision Super Action, Colecovision Standard, and the Atari Jaguar, I'm going to ned a cradle to hold a second joypad and y-adapters so I can control the keypad in mid game and use the original overlays without unplugging and replugging the stick. Also I might need a second middle controller button remapped adapter for THOSE systems so keypad presses can be actuated by joystick buttons for Mouse Trap.

© 2017 Brian Ciesicki. All Rights Reserved

Search Engine Optimization and Free Submission